Warnings: 1.This module requires a 3.3 volt supply for VCC, and 3.3V logic.
2.It is not 5V tolant,Connect RX or TX on 5V For Arduino will destroy this module.
3.You must use a logic level converter, or a 3.3V For Arduino
4.The 3.3V supply on the For Arduino has inadequate current capabilit to power this module.
5.You must provide a separate,higher 3.3V supply(about 300mA or better)
Description: This is WiFi serial transceiver module, based on ESP8266 SoC.The SOC has Integrated TCP/IP protocol stack.It is TTL serial communication interface and its parameters can be set by AT command. It is widely used in networking, smart home project when it is connected to the wifi router. It can be used for remote monitoring of home appliances, bedroom temperature and humidity, controlling home appliances and smart car by the mobile phone. Features: For Arduino R3 and the compatible board can directly connect to this module.
Interface logic voltage: 3.3V / 5V compatible(On-board level shift circuit)
Working voltage: 4.5V - 5.5V (On-board 3.3v LDO Regulator)
Working current: 240mA(MAX)
Serial port baud rate: 115200 (default), can be modified to other values by AT command
Serial communication format: 8N1
On-board reset button
On-board switch to select UART mode or firmware update mode
Antenna Type: Built-in ceramic antenna is available, and you can also use an external antenna.
Wireless Network Mode: station / softAP / SoftAP + station
Wireless criteria: 802.11 b / g / n
WIFI @ 2.4 GHz, support for WPA / WPA2 security mode
It is very easy to design projects by AT command Applications: Home automation, sensor networks, industrial wireless control, smart c
